Auto binding:
The receiver will enter the binding mode automatically after power is applied and it doesn’t receive a transmitter signal for 15 seconds. This is indicated by the slow flashing LED light changing to a rapid flash. The receiver is now in the binding mode, complete the binding operation according to your transmitter’s binding instructions.
Throttle calibration:
1. Start the process by connecting the motor to the receiver, please remove all props.
2. Turn transmitter (tx) on.
3. Advance throttle to full.
4. Apply power to the receiver, the receiver will cause the motor to beep out a tune, wait for it to end, (approx 5 sec) max throttle is now calibrated.
5. Pull the throttle back all of the way, this calibrates the minimum throttle. The motor will now beep out another tune and end with one low and one high tone beep, calibration is now complete, and the ESC is armed.
TELEM function:
The TELEM function monitors battery voltage, receiver working voltage, signal strength, as well as working temperature in real time.
NOTE: The effective control range of the TELEM function depends on the transmitter, it is quite often that the working range of the receiver is far more than TELEM function effective range.
SR3X Stabilization :
SR3X is a 3 axis flight stabilization system specially for fixed wing model airplanes. SR3X is controllable from the transmitter and has three working modes: off, low sensitivity, and high sensitivity. The default is for the mode selection to occur on channel 5. The stabilization mode is indicated on the receiver by a blue LED with the following indications: off, on steady (stabilization medium), flashing (stabilization high). If your transmitter only has a two position switch, you will have to allocate CH5 to a three position switch to use all three settings. Using the Crossover-RX USB Configuration Tool, you can select many additional options for the initial setup including horizontal or vertical mounting, differential thrust, aircraft configuration (flying wing, v-tail, etc.), and also mode selection channel. Also adjustable from the USB Configuration tool is the sensitivity of the SR3X stabilization in all modes and all axis.
CrossOver-RX Configuration Tool:
CrossOver-RX Configuration Tool is a firmware update tool for Crossover-RX products. With the USB adapter and the software found below, you can access many programming options and available firmware updates on various Crossover-RX products. Available with either a 3 or 4-wire M-BUS connection wire.
Current Version: 2.0.0 Click here to download
Unzip this file and install it on your PC. Open the software and with the receiver not plugged into a battery, plug in a MX-PG02 USB Programming Interface Module (UPIM) into the MBUS servo port and the USB end into the PC. Look at the diagram in the pictures to find which servo port is the MBUS port, other ports will not work. Look for USB-SERIAL CH30 in the port description box and select it, then press the connect button.
*Supported OS: WIN7-WIN11 X64 You may need to download the VC Runtime to run this application.
[ITEMPRICE]