An indoor remote controlled RC parkflyer kit made of CNC cut depron foam and plywood.
A very slow flier that loves to fly in small indoor areas or outdoors when winds are light. This model
requires a moderate level of building experience to complete. This cartoon scale model of the famous
Grumman F6F Hellcat is a joy to fly. It's very low aspect ratio wing is a delight indoors with it's very wide
speed range and handling characteristics. It is designed around the latest sub-2gram servos and 5gram
brushless motors and is setup for 1c power.
Made in the USA by
Buzzard Models LLC
Wing span : 12"
Wing area : 84 sq/in.
Length : 13”
Weight ready to fly: 1.4 ounces (40 grams)
Wing loading : 2.4 oz./sqft
Kit comes with the following parts:
one wing 3mm depron
one upper fuselage 3mm depron
one lower fuselage 3mm depron
two elevons 3mm depron
one rudder 3mm depron
two fuselage doubler 3mm depron
two spray-masks 3mm depron
three composite control horns
three .024 music wire pushrods with z-bends
Kit requires the following items for completion:
2 - 5 gram motor with appropriate propeller
Radio transmitter and micro receiver
Battery 130-250mah single cell lipo 20c
Three sub-micro <2grams servos
One micro 3 amp speed control
THIS IS A KIT ONLY, NO MOTOR OR ELECTRONICS INCLUDED, REQUIRES ASSEMBLY
$3.85 standard flat rate shipping on all standard dimension orders
All standard dimension orders over $100 are free shipping
Ships within 24 hours except on Sundays